• Induction Welding
  • Company Information  
    • Contact Us
  • Applications
  • Services  
    • Aftermarket Parts
    • Service and Training
    • Thermatool Labs Materials Engineering
  • Resources  
    • Technical Papers
  • Products
    • Articles
    • Events
    • Home
  • Email
  • Articles
  • Events
  • Home
  • Email
  • Induction Welding
  • Company Information
    • Contact Us
  • Applications
  • Services
    • Aftermarket Parts
    • Service and Training
    • Thermatool Labs Materials Engineering
  • Resources
    • Technical Papers
  • Products

    • Thermatool
      • High Frequency Welders
        • HAZControl™ Technology HF Welders
        • CFI High Frequency Welder
        • High Power High Frequency Welders
        • Spiral Fin Tube HF Welders
        • Dual Induction and Contact Welders
        • Compact High Frequency Welder
      • Quench and Temper
      • Engineered Structural Sections
      • Tube Heaters and Seam Annealers
        • Seam Annealers
        • Full Body Annealers
        • Mpower™ High Frequency Power Supply
      • Sensors and Controls
        • ThermaView™
        • SmartAnneal™
        • SeamScan™
    • Alpha
      • Flying Saws
        • CS-090 Cold Saw
        • CS2-170 Cold Saw
        • FS-170 Friction Saw
      • High Speed Flying Shears
        • Mach I Flying Shear
        • Mach II Flying Shear
        • Mach III Flying Shear
      • Sensors and Controls
        • Accelerator Upgrade
        • Flying Shear Controller Upgrade
    • Savage Saws
      • Ferrous and Non-Ferrous Cutting
        • Super Saw
        • Plate Saw
        • Lab Saw
        • Guillotine Saw
      • Specialty Cutting
        • Rotator Saw
        • Foundry Saw
      • Material Handling

News Room

Getting the Most Out of Your Alpha Cutoff. 01.20.2017

By: Mahmoud (Mike) Abbas, P.E., Thermatool Corp., USA With higher demands for productivity, it is essential that mill supervisors and managers take a closer look at their flying shears.  Most, if not all, flying cutoffs that were built in the last century are equipped with hydraulic accelerators and vintage controllers that are becoming obsolete.  These […]

News Room

Thermatool Corp. 31 Commerce St. East Haven, CT 06512 | Phone: 203.468.4100 | info@thermatool.com

Images and features throughout site are typical and may vary based on application.
  • Website Terms of Use
  • Privacy